car repair question?
car repair question?
how hard is it to replace a cam position sencor on a 1988 buick lasebre 3.8, is it expencive at repair shops , im in kentucky
Answers:
Chosen Answer
stallion1948_lloyd: its not hard.i got a 88 olds 3.8 and i replaced 1 on mine.all you do is disconnect the neg.cable of the battery and take off the belt and the wheel of the water pump and there it is.it has 1 bolt,you take out and just put the new 1 back in and tighten the bolt and put on the pulley and belt,then wait a few seconds and hook up the battery.hope this helps you.
2006-11-26 07:35:36
stallion1948_lloyd: its not hard.i got a 88 olds 3.8 and i replaced 1 on mine.all you do is disconnect the neg.cable of the battery and take off the belt and the wheel of the water pump and there it is.it has 1 bolt,you take out and just put the new 1 back in and tighten the bolt and put on the pulley and belt,then wait a few seconds and hook up the battery.hope this helps you.
2006-11-26 07:35:36
NEMO: its not hard at all at a shop part and labor under $120.
2006-11-26 07:45:44
2006-11-26 07:45:44
TripleXXXrated: No its not really that expensive at all. Probably run you 100-150 dollars depending on how much the sensor is. Its very easy to change if you know where it is and have the tools for the job.
2006-11-26 07:47:02
2006-11-26 07:47:02